Insights & Updates

First press the RST button to reset and observe if the gauge is under pressureIf no pressure is displayed, check again if the motor is workingPlease note that please turn off the power and wait for 10-15 minutes, and then start the oil pump after the motor temperature cools downThe intermittent oil Read More

1、Do not exceed the maximum use pressure when using(Maximum operating pressure 1MPa); Lubrication points2、Use lubricant viscosity 10-32cst; 3、Please use clean and brand new lubricant, do not use recycled lubricant. Read More

The system is equipped with a solenoid valve and a pulse valve for precise control of the air source, and the spray frequency can be directly adjusted through the pulse valve; Oil and gas are output by concentric tubes and mixed at the nozzle for high speed spraying. The volume of gas supply and Read More

The iron shell motor shall be low-pressure cycle cooling and lubricating system. Oil delivery of the pipeline is steady and low noise. Applicable for main shaft cooling and lubricating, guide rail lubricating and other conditions. Read More

Performance and characteristics1,The system is equipped with pressure regula Read More

ol the working times of the oil and gas mixer according to actual needsPlease connect the pipeline correctly to ensure that the pipeline does not leak After the pipeline is connected,please make the oil-gas mixer work continuously for several times until the oil is discharger from the oil outlet pip Read More